ZONEMIX4 Zone Controller Instructions
PAMBUKA
Port aksesori ZONEMIX ngidini sambungan panel tembok, stasiun paging lan sumber input audio. Tututi pandhuan ing ngisor iki kanggo nyiyapake sistem sampeyan.
Please note that accessory port local audio input channels are locked to the corresponding output zone and only one can be used per zone. E.g. Accessory port 1 local input connects to Zone 1.
However, multiple wall panels and paging stations can be connected on the same accessory port.
STEP 1: Nemtokake PORT WIRING LAYOUT
LANGKAH 2: KONFIRMASI AJA NGLEBIH WATASAN IKI
Jarak maksimum sing dikutip ing tabel amarga watesan arus DC.
Stasiun paging lan panel tembok bisa didhukung sacara lokal kanggo nambah dawa kabel nganti maksimal 500m. Waca dokumen tambahan ing ngisor iki: Pandhuan kabel port aksesori canggih.
STEP 3: AKSESORI PORT WIRING
Sambungake stasiun paging ZONEMIX lan ZMPS kaya gambar ing ngisor iki.
- Kategori 5, 5e lan 6 kabel didhukung.
- T-568A wiring recommended. However, T-568B also supported.
Sambungake panel tembok kaya gambar ing ngisor iki.
- Kategori 5, 5e lan 6 kabel didhukung.
- T-568A wiring recommended. However, T-568B also supported.
STEP 4: PORT TERMINATION - AJA skip STEP INI
The ZONEMIX uses the RS485 standard to communicate to wall panels and paging stations.
RS485 requires that each end of the cable run is terminated to prevent signal corruption due to signal reflections in the cable.
Port Aksesori diklompokaké ing Pasangan. 1+2, 3+4, 5+6, 7+8. Sampeyan kudu mungkasi ZONEMIX lan Aksesoris adhedhasar port sing sampeyan gunakake.
LANGKAH 5: WP4R, WP10 GPO WIRING (OPTIONAL)
WP4R lan WP10 loro-lorone duwe 3 output tujuan umum sing bisa dikontrol saka tombol panel tembok kanggo micu piranti eksternal kayata proyektor.
Waca Liyane Babagan Manual Iki & Unduh PDF:
Dokumen / Sumber Daya
 |
ZONEMIX ZONEMIX4 Zone Controller [pdf] Pandhuan ZONEMIX4, ZONEMIX4 Zone Controller, Zone Controller, Controller |